JU017-6B
JU017-6 is a two-component polyurethane adhesive with optical transparency. It is suited for LED packaging or components protection.
Categories:
LED Adhesive- This product complies with the RoHS-2 standard low viscosity system that can be used on various applications.
- This product offers high weather, UV, and hydrolysis resistance.
- The mixing ratio by volume of this product is 2：1, which makes it easy to process.
- This product demonstrates strong anti-yellowing ability when exposed to UV light.
| Properties | Value |
|---|---|
| Appearance | Liquid |
| Color | Colorless |
| Viscosity 25oC, cps | 1,000 ~ 2,000 S14 100rpm |
| Specific Gravity | 1.14 |
| Properties | Value |
|---|---|
| Mix Rate (A：B) by Volume | 2：1 |
| Mix Rate (A：B) by Weight | 100：52 |
| Pot Life, 25 oC, min | 5 |
| Gel Time, 25 oC, h | 10 |
| Surface Dry Time, 25 oC, hr | 24 |
| Cure Time, 25 oC, hr | 48 |
| Through Cure Time, 25 oC, days | 7 |
| Properties | Value |
|---|---|
| Hardness, Shore A | 65 |
| Specific Gravity | 1.14 |
| Shrinkage, % | <1 |
Note : *1 Specimen Cure Condition: 25°C / 48hr + 60°C / 1hr
- This product should be applied to a clean surface that is free of dirt, grease, or mold. In many cases, a simple solvent wipe is sufficient.
- Mix thoroughly by volume 2：1. Mix approximately 30 seconds after uniform color is obtained.
- For maximum bonding strength, apply adhesive evenly to joint surfaces.
- The handling information of this product supplied in dual syringe cartridge can be obtained by requesting a copy of “Introduction for Adhesive Cartridge Dispenser”, F-06122201.
- Cure time on the actual part will depend on factors, such as part geometry, materials to be bonded, bondline thickness and efficiency of the oven. Cure schedule should be confirmed with actual production parts and equipment.
The product should be stored in a cool and dry place. Both Part A and B should be kept tightly sealed. After use, please close the lid as soon as possible and avoid long-term exposure to air. It is recommended that the operator promptly close the lid after use to prevent any moisture exposure. Shelf life of this product is 6 months when stored below 14~34 oC in the original, unopened containers.
Some findings indicate a lack of potential for carcinogenicity with the compositions of this product by long-term recurrent application to the skin. However, contact with skin is likely to produce mild transient reddening. It is important to remove adhesive from skin thoroughly with soap and water. DO NOT use solvents for cleaning hands
This product has moderate acute toxicity when swallowed. If swallowed, call a physician. Avoid contact with eyes. In case of contact, flush with water for at least 15 minutes and get medical attention immediately. For specific information on this product, consult the Material Safety Data Sheet.