Solar Potting Compound
Flexibond7360W is a two-component room temperature condensation dehydrated silicone potting adhesive, which is suitable for potting protection of electronic capacitor products in photovoltaic junction box. Mixed in the ratio of A:B=6:1 (quality ratio), it will generate a protective material with good elasticity after curing
Categories:
Solar Adhesive- Strength adhesion to junction boxes, backplanes, electronic components, and PC plastics
- Low viscosity, good fluidity, can be poured into narrow gaps
- Small shrinkage during curing, better water-proof and moisture-proof performance
- Curing at room temperature, good self-defoaming performance, easy to apply
- Excellent insulation performance, high flame-retardant level
- Good anti-aging performance, can maintain good elasticity for a long time at -40 ~ 150 °C
| Item | Value |
|---|---|
| A component appearance | White liquid |
| B component appearance | Transparent liquid |
| A component viscosity(mPa·s) | 5000-8000 |
| B component viscosity(mPa·s) | 50-300 |
| A.B mixing ratio (quality ratio) | 6:1 |
| Viscosity after mixing(mPa·s) | 3000-6000 |
| Tack-free time (min) | 10-40 |
| Initial curing time (h) | ≤2 |
| Density (g/cm) | 1.20 -1.25 |
| Shore A hardness | 20-50 |
| Heat conductivity(W/m·K) | ≥0.2 |
| Breakdown voltage strength (kV/mm) | ≥18 |
| Volumetric resistivity (Ω·cm) | ≥1.0×1014 |
Widely used in the potting and protection of photovoltaic junction boxes, precision electronic components, electronic modules, electrical modules, lighting appliances, power supplies and circuit boards.
- Weight A and B in the ratio of 6:1 quality, then mix and stir well, pour the well mixed adhesive intothe product within the operation time, it can be poured several times if the product is too large, and then cure according to the curing conditions referring to the above table.
- Precipitation will occur if the adhesive is stored for too long time. It is necessary to stir components A and B separately before mixing. Unmixed adhesive should be sealed and stored well in package, especially component B.
- When stirring, please stir in the same direction, otherwise too many air bubbles will be mixed in; the adhesive on the frame and bottom of the container should also be stirred evenly, otherwise there maybe local uncured phenomenon.
- Vacuumize and defoam again after potting on the product, which can improve the comprehensive performance of the adhesive after curing.
- The curing speed of this product will change due to the difference in temperature and humidity. After receiving the samples, please test the curing speed in advance to meet the on-site process.
- Please consult our technical staff for product characteristics and production process suggestions when use this series of products for the first time.
- 12kg
- Pail 2kg
- Jug
- It is the non-dangerous chemical
- Component A should be protected from light and heat, and be sealed stored.
- Component B is flammable when exposed to open flame
- Shelf Life: 6 months under 25℃
The data in this sheet are reliable information obtained under laboratory conditions. Due to differences in the actual operating environment, users should refer to these data and operating conditions for analysis and testing. Comens does not guarantee the correctness and suitability of the products soldunder certain specific conditions. Comens does not assume any liability for direct, indirect or incidental damages for problems arising from the use of the product for a specific purpose. Users who encounter technical problems in the course of use may contact Gaumont's technical service department.